Thermal transfer label printer MERTECH TLP300 TERRA NOVA USB, RS232, Ethernet Black

The MERTECH TERRA NOVA TLP300 printer is designed for thermal printing of labels and receipts. It can print on paper, textile, synthetic ribbons, adhesive labels, thermal tape, and labels. It is a model with a modern mechanism, improved system board, practical design and compact size. The TLP100 differs from the TLP100 in that it has a larger ribbon capacity (300 meters instead of 100 meters).

Model Advantages

NOVA TLP300 thermal printer from MERTECH Equipment has a lot of advantages:

1. Printing speed of 127 mm/sec. Expansion can be adjusted in the range of 203 DPI.
2. The system board supports printing one- and two-dimensional bar codes (PDF417 and QR code).
3. The Easy Load feature allows you to change a ribbon or cash register ribbon in 10 seconds.
4. 3 interfaces available for connection to POS system: USB, Ethernet, RS-232C.
5. Functionality: up to 10000 receipts and labels per work shift.
6. Integration with UGAIS system is available.
7. Low noise level: up to 50 decibels (no louder than a voice).

Intelligent system board is installed inside. The device supports two protocols for thermal printing: ZPL protocol from Zebra and TSPL protocol from TSC. The model is compatible with BARTENDER software. This is an American print management software. The software was created by Seagull Scientific.

Specifications

Stationary printer NOVA TLP300 has small dimensions. It is 285 mm long, 226 mm wide, and 171 mm high. The printer does not take up much space on the table. The model is suitable for any type of business. It is used in salesrooms, warehouses and offices, pharmaceutical companies.

The device is equipped with 4 sensors:

1. Fixed transmitting.
2. Adjustable reflective.
3. Tape end control.
4. Monitoring the position of the thermal head.

If the sensor registers an error, light and sound indication starts. MERTECH TERRA NOVA TLP300 prints labels and receipts of length 15-1200 mm, width 108 mm. The maximum length of the ribbon is 300 meters.

Various materials are suitable for printing. You can print on labels with a tear, a hole with a black mark. Use ribbon based on resin, wax, or a mixture of materials. But print quality depends not only on the device, but also on the chosen substrate.

Completion

The package includes the printer itself, instructions and warranty card, label tape and ribbon. Before you start, you need to install the drivers from the service website. After installing the drivers you can connect the device to the POS-system, change its settings, set the appearance of receipts and labels.